When it comes to packaging for your electronics, electrical isolation and complex cross-section patterns are often required. The solution? Form-in-Place (FIP) gaskets. Form-in-Place (FIP) gaskets are hugely important in the manufacturing industry, recognized widely as a cost-effective, functional seal for dense electronics packaging. FIP can replace wire mesh gaskets, molded-in-place or die-cut gaskets. Characteristics of […]
Too often with mechanical, electrical and other software systems, this testing is not a priority, resulting in performance failure. Read on for tips on how to navigate compliance testing for your device.
Vent Cover Design Provides EMI Shielding The Challenge A unique, energy-efficient light spectrum indoor grow light was developed for large scale commercial indoor agriculture, but produced emissions and needed several design changes to perform optimally. It was important that the manufacturer covered the dual light bulbs and added EMI/RF shielding to protect the electronics. Design […]
The ChallengeThe consumer demand for electric vehicles (EVs) and hybrid electric vehicles (HEVs) has skyrocketed over the past several years and can only be expected to continue to grow. As that demand increases, manufacturers must also consider the increased demand in 12V and 24V accessories which have traditionally been powered by an alternator. For EVs […]
Why You Should Start Switching to Adhesives Today The transition from mechanical fasteners to adhesives will often require a period of time for engineers as they test the efficacy and strengths of different adhesives. This trial period will allow engineers to find the best adhesive for each given product. Finding a supplier already knowledgeable in […]